Replacement LCD Screen Display For LPM140M420 14.0 inch WQHD Glossy 500nit Panel

Replacement LCD Screen Display For LPM140M420 14.0 inch WQHD Glossy 500nit Panel.

Product details

Panel code — this listing

LPM140M420. Read the code on the label on the back of the screen you are removing and compare it with this one. Some suppliers write the same panel as LPM140M420 A or LP140M420 — the strings differ, the panel does not

Screen size

14.0 inches diagonal (35.6 cm), 16:9

Resolution

2560 x 1440 px (WQHD), 210 PPI

Refresh rate

60 Hz. One factory record also notes a 48 Hz dynamic refresh mode on this panel; the machines below run it at 60 Hz

Panel technology

LTPS TFT-LCD, IPS wide-viewing-angle panel (normally black, transmissive, 88/88/88/88), 16.7M colours, with a WLED edge-lit backlight and the LED driver on the panel board

Surface finish

Glossy (Haze 0%) with a hard coating, consistent across the factory records. If the front of the screen you are removing is matte you need the anti-glare part instead — same frame, same connector, different surface

Touch

No — this is the non-touch panel supplied on its own, with no touch layer and no digitizer glass. If the screen you are removing responds to your finger, you need the touch assembly instead and this panel is not it

Connector position

Bottom right, viewed from the back of the panel

Device

Model numbers / part codes

Panel code covered — this listing

LPM140M420

NOT the Full HD panel

The X1 Carbon and T-series machines also shipped with 14.0 inch Full HD 1920x1080 panels on a 30-pin connector. Different resolution, different pin count, different part — a Full HD machine will not drive this WQHD panel

NOT a touch assembly or a full display

This listing is the non-touch screen panel on its own. Touch screens for these machines are separate assemblies with the digitizer built in, and they are not interchangeable with this bare panel

Compatibility

LPM140M420 14.0 inch WQHD Glossy 500nit Panel

Match the listed LPM140M420 14.0 inch WQHD Glossy 500nit Panel model and part configuration before selecting a replacement.